Special Website

(Iron & steel works, transformers, floating roof tanks, ...)

© Copyright 2007 MultiMetall

Rapid curing for use with Hardener yellow possible!

Whenever Hardener yellow is used, the curing process can be accelerated by heat addition. For this purpose the metallic substrate and not the PolymerMetal must be warmed up after application. A temperature of 70 °C over a period of one hour is enough for remarkable good technical data of dimensionally stable layer thicknesses up to 10 mm. The metal temperature should not exceed a maximum of 120 °C. The quick curing procedure can even be carried out at ambient temperatures below 0 °C.

Above mentioned information has already been embedded in the latest versions of the concerned technical data sheets which will be sent to you upon request immediately.

Requesting Technical Data Sheets